Rerode R1 Hitch Carrier / Bike Rack: Compatibility Guide
Rerode R1 & R1+ Hitch Carrier / Bike Rack: Compatibility Guide
If you're riding a Rerode and looking for the cleanest way to haul it, a hitch carrier beats truck beds and cargo vans every time - no ramps on every trip, no scratched paint, no rearranging your whole vehicle.
The Charge Carrier fits the Rerode R1 and R1+. Here's everything you need to know before your first haul.
Compatible Models
- Rerode R1
- Rerode R1+
How the Charge Carrier Mounts Your Rerode
The Charge Carrier uses a Secure Anchor Bolt System that locks directly through your bike's foot pegs. Unlike ratchet strap-only carriers, the bike stays planted - no shifting on the highway, or off-road.
Three adjustable brackets ship with the carrier (two leveling, one flat). Both Rerode models mount using the leveling brackets to keep the bike sitting level on the carrier.
Kickstand Sensor
Both Rerode models sit level on the carrier without stressing the kickstand sensor. No bypass, no modification required - no shifting on the highway or off-road.
Hitch Requirements
Receiver size: 2 inch
Hitch class: Class III, IV, or V
Carrier weight: 22 lbs
Weight capacity: 400 lbs
Check your vehicle's tongue weight rating before loading.
Hauling Two Rerodes
The Charge Carrier Add-On expands your setup to carry two bikes on the same hitch.
Weight capacity (dual config): 200 lbs per bike
The Add-On connects using connector plates and four bolts - on or off in a few minutes.
Storage Between Rides
Smart Storage Mode flips the carrier vertically against your vehicle when not in use. It stays installed between sessions without sticking far out on your vehical.
Shop the Charge Carrier
Ready to haul your Rerode R1? Everything you need is below.