Lift Light: The First Peg Brace Wheelie Light for E-Motos
Lift Light: The First Peg Brace Wheelie Light for E-Motos
Pull a wheelie at night and your headlight points straight at the sky. The trail in front of you goes dark right when you need to see it most. The Lift Light fixes that.
It's a full replacement for your e-moto's peg brace with a headlight built into the brace itself. The light rides low and throws forward even when the front wheel is up. A headlight where you need it, when you need it.
What the Lift Light Is
The Lift Light replaces the stock peg brace that sits between your foot peg mounts. In its place, you get a CNC-machined brace with an integrated LED pod - same structural job as your old brace, plus a 2,000-lumen headlight built into the design.
CNC'd in the USA.
A Wheelie Light, Built In
Because the light sits down on the peg brace instead of up on the fork, it stays aimed at the trail when you loft the front end. That's the whole point — a wheelie light that keeps the ground lit while you're up on the back wheel. Off the wheelie, it doubles as forward-facing underglow that makes the bike look mean and keeps you seen.
Specs
- Output: 2,000 lumens
- Power: 20W
- Color temperature: 6000K (clean white)
- Housing: CNC-machined aerospace-grade 6061 aluminum
- Connector: Plug-and-play H4
- Function: Wheelie light + underglow
- Origin: Made in USA
- Patent pending
Modular & Adjustable Fitment
The Lift Light is designed to fit a wide range of e-motos that share the standard peg-brace mounting. It ships with the standard H4 connector found on bikes like the Sur-Ron Light Bee and E Ride Pro, so on those it's a true plug-and-play swap — pull the old brace, bolt in the Lift Light, plug in the harness, done.
Plug-and-Play Install
No splicing, no controllers, no tapping into your wiring. The Lift Light uses the same H4 connector your bike already runs:
- Remove your existing peg brace
- Bolt the Lift Light in its place
- Plug the H4 connector into your headlight harness
A few minutes with basic hand tools and you're lit.
*these are the models that work for replacing the existing peg brace. The wiring harness included is the standard H4 connector that's plug-and-play for the Surron Light Bee and other emotos that use the Surron headlight connector
Compatible E-Motos
- Surron Light Bee
- E Ride Pro S
- E Ride Pro SS 2.0
- E Ride Pro SS 3.0
- E Ride Pro SR
- Talaria Sting MX3
- Talaria Sting MX4
- Talaria Sting MX5
- Vetra Blazer
- Arctic Leopard XE Pro
- Arctic Leopard XE Pro S
- Rerode R1
- Rerode R1+
- Throne SRPNT X3
- 79Bike Falcon Pro
- 79Bike Falcon GT
*these are the models that work for replacing the existing peg brace. The wiring harness included is the standard H4 connector that's plug-and-play for the Surron Light Bee and other emotos that use the Surron headlight connector